Avaya S8700 - Test the IPSI Circuit Pack; Test Expansion Interface Circuit Packs (S8700 Multi-Connect Only)

192
Installing the S8700 IP Connect
May 2002
Test the IPSI Circuit Pack
Use Avaya Site Administration.
1 Type test ipserver-interface UUC and press Enter to test all clock and packet interface
components within the IPSI circuit pack.
2 Verify the screen displays Test Results screen similar to ‘‘Sample IPSI 01A Test Results
Screen — Page 1, S8700 Multi-Connect’’ on page 192.
Sample IPSI 01A Test Results Screen — Page 1, S8700 Multi-Connect
Test Expansion Interface Circuit Packs (S8700
Multi-Connect only)
Check each Expansion Interface (EI) circuit pack in the media gateway.
1 Type test board UUCSS where UUCSS is the cabinet, carrier, and slot for an Expansion
Interface (EI) circuit pack in the media gateway, and press
Enter.
NOTE:
Labels on the port network and carrier and on the strip under the circuit pack contain this
information.
2 Verify the screen displays test results similar to ‘‘Sample Test Results for Expansion
Interface Board 2A01—S8700 Multi-Connect’’ on page 193. This example is for board
2a01.
3 If any result is FAIL, check the connections for the fiber optic link.
4 Repeat Steps 1 and 2 for each Expansion Interface circuit pack.
test ipserver-interface 1a Page 1
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
01A TONE-BD 46 PASS
01A TONE-BD 52 PASS
01A0201 ETR-PT 42 PASS
01A0201 ETR-PT 43 PASS
01A0202 ETR-PT 42 PASS
01A0202 ETR-PT 43 PASS
01A0203 ETR-PT 42 PASS
01A0203 ETR-PT 43 PASS
01A0204 ETR-PT 42 PASS
01A0204 ETR-PT 43 PASS
01A0205 ETR-PT 42 PASS
01A0205 ETR-PT 43 PASS
01A0206 ETR-PT 42 PASS
01A0206 ETR-PT 43 PASS
01A0207 ETR-PT 42 PASS
press CANCEL to quit -- press NEXT PAGE to continue