Avaya S8700 - Cabling 2 Media Gateways

60
Installing the S8700 IP Connect
May 2002
Cabling 2 Media Gateways
1 Remove the bottom panel from media gateway B.
2 If not already removed, remove the fan assemblies from media gateways A and B.
3 Remove the right TDM/LAN bus terminator from media gateway A, and install it at the
left end of the TDM/LAN bus on media gateway B. See ‘‘Shift TDM/LAN bus
terminator from media gateway A to media gateway B’’ on page 60.
!
WARNING:
Make sure to install the TDM/LAN bus terminators with the arrow on the back pointing
upward.
Shift TDM/LAN bus terminator from media gateway A to media gateway B
4 Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable
routing slot of media gateway B and the top right TDM/LAN cable routing slot of media
gateway A. See ‘‘TDM/LAN bus cable routing slot plate removal’’ on page 61
Figure notes
1 EMI Gasket between media gatewasys 2 TDM/LAN bus terminators
cadptdm2 KLC 102600
TO
P
B
2
TO
P
A
2
TOP
2
1