61
Installing the S8700 IP Connect
May 2002
TDM/LAN bus cable routing slot plate removal
5 Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
both media gateways. Push the free end of the EMI Gasket back in place. Make sure the
open corner of the gasket faces the rear of the media gateway. Once installed, the top
media gateway should rest on and compress the gasket. See ‘‘TDM/LAN bus cable
routed through the media gateway’’ on page 62.
Figure notes
1 Media gateway B routing
slot plate
2 Media gateway A routing slot plate
cadptdm3 KLC 102600
A
B
TO
P
TO
P
1
2
2
1
To Next Page
Loading...
