Avaya S8700 - Install Circuit Pack Adapters

64
Installing the S8700 IP Connect
May 2002
5 Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
both media gateways. Push the free end of the EMI Gasket back in place. See
‘‘TDM/LAN bus cable routed through the media gateway’’ on page 62
.
6 Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus
in media gateway C. Make sure the arrows on the back of the cable terminators point
upward.
7 Install the upper terminator of the TDM/LAN bus cable on the right end of the
TDM/LAN bus media gateway D.
8 Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the
ends of the routing slots are covered.
9 Reinstall the fan assemblies and bottom panel on each media gateway.
Install Circuit Pack Adapters
1 Install the IP Media Processor adapter and 259A C-LAN adapter (if used) on the
appropriate connectors behind the media gateways. See ‘‘Avaya G600 adapter
connections’’ on page 64.
2 Install the IP Server Interface adapter to the slot 2 connector on the back of media
gateway A.
Avaya G600 adapter connections
Figure notes
1 IP Media Processor adapter
2 259A adapter for C-LAN (if used)
3 IP Server Interface adapter (slot 2)
crdladp LJK 022302
2
1
3