18
Installing the S8700 IP Connect
May 2002
Configure Server 1
This section covers the following tasks:
• ‘‘Copy license and Avaya authentication files from laptop to server 1’’ on page 24
• ‘‘Install the license and Avaya authentication files’’ on page 25
The following administration uses the services laptop computer and the media server web
interface.
NOTE:
Make sure you have the complete list of IP addresses and host names before starting this
process.
NOTE:
Make sure your networking and Web browser settings are correct. Refer to the Job Aid
entitled Pre-Installation Information--S8700 IP Connect
.
1 Plug server 1 into UPS 1 to power it up. Refer to Getting Started with the Avaya™ S8700
Media Server for IP Connect Configurations.
2 On your laptop computer, click Start > Run to open the Run dialog box.
3 Type command and press Enter to open a MS-DOS Command Line window.
4 Type arp -d 192.11.13.6 and press Enter to clear the ARP cache in the laptop. This
command will respond with one of the following:
• The command line prompt when the cache has been cleared.
• The phrase: The specified entry was not found. This is returned when the
specified IP address does not currently contain an entry in the ARP cache.
5 Launch the Web browser.
To Next Page
Loading...
