Avaya S8700 - Hard-Wire Bridging; Dual Wiring of Two-Wire and Four-Wire Endpoints; Install the Attendant Console

122
Installing the S8700 IP Connect
May 2002
Hard-Wire Bridging
Analog type hard-wire bridging is not allowed for any DCP endpoints. Hard-wire bridging
provides no way of combining the digital output of two bridged DCP sets. Also, a bridged
endpoint causes degradation of the DCP signal.
!
CAUTION:
Bridging or paralleling these endpoints can cause electrical damage to the consoles or
cause the circuit pack to remove power from the consoles.
Dual Wiring of Two-Wire and Four-Wire Endpoints
Do not simultaneously wire a two-wire and four-wire endpoint to the same equipment location
in an MDF. The Avaya configurations use separate circuit packs to interface two- and four-wire
endpoints.
Install the Attendant Console
1 Install the Attendant Console and connect the modular cord to the information outlet.
2 Install labels per the Attendant Console form and the Display Module form assignments.
3 Install a Digital Line circuit pack in the assigned carrier slot (if an additional circuit pack
is required).
4 Administer the forms listed in “Attendant Console” in Administrator’s Guide for Avaya
MultiVantage Software.
302D Console