Avaya S8700 - TN799 DP Control LAN; Installing a TN799 DP C-LAN; Installing the Cables

86
Installing the S8700 IP Connect
May 2002
TN799DP Control LAN
The TN799DP Control LAN circuit pack serves two purposes:
• A connection for the signaling (telephone) network to the customer’s data network for IP
telephones.
• A source board for downloading firmware to circuit packs having the "P" designation.
• An IP interface for adjuncts such as Intuity Audix
• An IP interface for DCS connection with another Avaya configuration.
See the Avaya MultiVantage Solutions Hardware Guide for more information.
Installing a TN799DP C-LAN
Installing the cables
1 Install a cable from the cabinet to the network through a hub or 110 (purple) wall field as
required. Connect the 259A adapter to the Amphenol connector corresponding to the slot
that the C-LAN circuit pack is in. See ‘‘Cable Connection for C-LAN’’ on page 87
. For a
pinout of TN799DP, see ‘‘TN799DP Pinout’’ on page 87
.