Avaya S8700 - Installing the TN2302 AP IP Media Processor; Connect the Cables for TN2302 AP; Connect the Cables for TN799 DP; Connect the Ethernet

90
Installing the S8700 IP Connect
May 2002
TN2302AP Amphenol Adapter
Installing the TN2302AP IP Media Processor
Connect the cables for TN799DP
1 Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
From the rear of the media gateway:
2 Connect a 259A connector to the Amphenol connector corresponding to each TN799DP
slot.
3 Connect one end of each DW8 cable to each 259A connector.
Connect the cables for TN2302AP
1 Determine into which port slots you are putting the TN2302AP IP Media Processor
circuit packs.
From the rear of the media gateway:
2 Connect the amphenol connector on the adapter to the Amphenol connector
corresponding to each TN2302AP slot.
Connect the Ethernet
1 Connect the network cable(s) to the ETHERNET connector on the TN2302AP backplane
adapter(s).
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Figure notes
1 Amphenol connector to backplane
connector corresponding to
TN2302AP slot
2 To network
3 9-pin connector for
maintenance
addfipm2 KLC 083000
1
2
3