Avaya S8700 - Page 29

29
Installing the S8700 IP Connect
May 2002
13 Click Configure Server to open the first page of the Configure Server wizard.
14 Select Avaya S8700 Media Server for IP Connect Configurations and click
Continue.
15 Click through the Review Notices to get to the Set Server Identities page.
NOTE:
Most of the fields are populated with default settings. Do not change the defaults unless
the customer’s network administrator requests it (refer to the filled-out Job Aid entitled
Pre-Installation Network Worksheet—S8700 IP Connect).
16 Fill in the fields on this and the subsequent pages:
• Configure Interfaces
• Configure Switches
• Set DNS/DHCP
• Set Static Routes
• Configure Time Server
• Set Modem Interface
• Update System
NOTE:
The server is not configured until you click Continue on the Update System page.
17 When you complete all the fields, the Update System screen displays each configuration
task as it completes it. The last line says "System modifications completed."
18 Scroll down to view the software release number. Verify that it is the current software
release (check against the Software Release Letter that comes with the software CD).
If it is the current software release, go to ‘‘Install License and Avaya Authentication
Files’’ on page 23.
If it is not, go to ‘‘Copy license and Avaya authentication files from laptop to server 1’’
on page 24, then go to Upgrading Software on an Initial Installation of an Avaya™
S8700 Media Server.