48
Installing the S8700 IP Connect
May 2002
4 Using the Rack Mounting Guide, locate a set of rack holes to be used for mounting. Note
the position of the upper key-hole shaped slots on each rail.
NOTE:
The mounting screw holes in some commercial racks are not evenly spaced. Make sure the
holes selected for mounting the RMC are such that the rack holes match all the mounting
bracket slots on the Guide. See ‘‘Rack hole spacing and first mounting screws placement’’
on page 49.
!
WARNING:
Installing the top media gateway higher than shoulder level on the rack is not
recommended.
5 Insert two mounting screws into the left and right rails of the rack in the holes noted in
step 4. Leave enough space between the screw head and the rail surface to accept the
mounting bracket. See ‘‘Rack hole spacing and first mounting screws placement’’ on
page 49.
!
DANGER:
Use lifting precautions! An empty Avaya G600 Media Gateway weighs 16–18 kg
(35–39 lbs).
6 Lift the empty media gateway and slide the key-hole slots on the mounting brackets onto
the two mounting screws.
To Next Page
Loading...
