8
Installing the S8700 IP Connect
May 2002
Analog Tie Trunk Example 111
Digital Tie Trunk Example 111
DS1 Tie Trunk Example 112
Collocated DS1 Tie Trunks 112
DS1 Tie Trunks Using T1 Channel Service Unit 113
Auxiliary Connector Outputs (MCC1 and SCC1 media
gateways only) 115
Three-Pair and Four-Pair Modularity 118
Adjunct Power Connection Locations 119
Attendant Console Example 120
Task List: Attendant Console Procedures 120
Attendant Console Cabling Distances, Local and
Phantom Power 120
Auxiliary Power 121
Hard-Wire Bridging 122
Dual Wiring of Two-Wire and Four-Wire Endpoints 122
Install the Attendant Console 122
Install the 26B1 Selector Console 123
Connect External Alarm Indicators and Auxiliary Power 123
Connect Power Distribution Unit External Alarm Wires 124
Remote Access 127
Install Off-Premises Station Wiring 128
Off-Premises or Out-of-Building Stations 128
• Off-Premises Connections 129
Off-Premises Protection Requirements 131
Telephone Restrictions for Exposed Environments 132
Digital Out-of-Building Telephone Protection 132
Installing the ITW Linx Enhanced Protector 133
Installing the 4C3S-75 Enhanced Protector 133
Installing the Data Link Protector 133
Emergency Transfer Units and Associated Telephones 134
808A Emergency Transfer Panel and Telephone Installation
Examples 135
Task List: Typical Emergency Transfer Panel and
Telephone Installation 135
Install the 808A Emergency Transfer panel 137
Install Telephones Used Only for Emergency Transfer
(Trunk/Auxiliary Field) 142
Install Telephones Used for Emergency Transfer and as
Normal Extension (Trunk/Auxiliary Field) 143
To Next Page
Loading...
