EasyManuals Logo

Avocent MERGEPOINT SP MANAGER User Manual

Avocent MERGEPOINT SP MANAGER
236 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
Parameter Command
bootconf
Use the set command to configure boot configuration.
Synopsis: set bootconf wdt <yes|no> mac <mac address> ip <ip address> bootfile
<file name> serverip <tftp server ip> baudrate
<1200|2400|4800|9600|19200|38400|57600|115200> fecmode1|fecmode2
<auto|100F|100H|100F|10F|10H> BF_curr < 0| 1 |2>
Example: set bootconf wdt yes mac 00:60:2e:01:d9:a6 ip 172.26.25.177 bootfile
uImage.4.0.0.28 baudrate 9600 fecmode1 auto fecmode2 auto BF_curr 1
NOTE: This parameter is only for the MergePoint SP5x24/SP5x40 manager.
dhcpd setting subnet
Use the set command to configure dhcpd settings.
Synopsis: set dhcpd setting subnet <subnet name> range_low <start ip> range_high
<end ip>
Example: set dhcpd setting subnet 199 range_low 199.1.1.1 range_high 199.1.1.160
dhcpd setting relay
Use the set command to specify a DHCP relay server.
Synopsis: dhcpd setting relay server <relay server> status <yes/no>
Example: set dhcpd setting relay server 172.26.25.3 status yes
dhcpd mapping
Use the set command to specify an IP address for added MAC.
Synopsis: set dhcpd mapping <MAC_address> ip <ip_address>
Example: set dhcpd mapping 00602e01d9a6 ip 1.1.1.1
NOTE: See the add command for the following paramter: dhcpd on page 128.
138 MergePoint® SP Manager Installer/User Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Avocent MERGEPOINT SP MANAGER and is the answer not in the manual?

Avocent MERGEPOINT SP MANAGER Specifications

General IconGeneral
BrandAvocent
ModelMERGEPOINT SP MANAGER
CategoryNetwork Hardware
LanguageEnglish

Related product manuals