Avocent MERGEPOINT SP MANAGER User Manual

Targets Description
/admin1/map1/ipendpt1
IP address of MergePoint SP manager. For an example procedure using this
target, see MergePoint SP appliance commands on page 157.
/admin1/map1/nodemanagesvc1
The servers on the side navigation bar. For an example procedure using this
target, see To add a server to the side navigation bar: on page 160.
/admin1/map1/oemavocent_
discoverysap1
The automatic discovery service access points (IP address range for the IP
addresses of the service processors). For an example procedure using this
target, see To configure automatic discovery: on page 159.
/admin1/map1/sshsvc1
The SSH service on the appliance. For an example procedure using this
target, see MergePoint SP appliance commands on page 157.
/admin1/map1/swid[n]
To upgrade the appliance and roll back to the previous version. For an
example procedure using this target, see To upgrade MergePoint SP
manager firmware: on page 162 and see To roll back the firmware to a defined
version: on page 162.
/admin1/map1/telnetsvc1
The Telnet service on the appliance. For an example procedure using this
target, see MergePoint SP appliance commands on page 157.
/admin1/system[n]
The managed servers. For an example procedure using this target, see To
reset a managed server: on page 165.
/admin1/system[n]/fan[n]
A managed server’s hardware fans. For an example procedure using this
target, see To check fan data on an managed server: on page 166.
/admin1/system[n]/log1/record[n]
A managed server’s event log records. For an example procedure using this
target, see To manage system event logs on a managed server: on page 168.
/admin1/system[n]/sensor[n]
A managed server’s hardware sensors. For an example procedure using this
target, see To check sensor data on an managed server: on page 165.
/admin1/system1/textredirectsap[n]
The console redirection service. For an example procedure using this target,
see To start a console redirection to an service processor: on page 166.
Starting a SMASHCLP session
To start a SMASHCLPsession, start an SSHsession and then enter the clp command.
To start a SMASHCLPsession:
1. Start an SSHsession. See Using SSH with the MergePoint SP Manager on page 104.
Chapter 8: Using SMASH Command Line Protocol 155

Avocent MERGEPOINT SP MANAGER Specifications

General

Brand	Avocent
Model	MERGEPOINT SP MANAGER
Category	Network Hardware
Language	English