Avocent MERGEPOINT SP MANAGER User Manual

To view the settings of the default SP profiles:
1. Click SP - SP Profiles.
2. Select the desired SP profile in the Default SP Profiles area.
To delete user SP profiles:
1. Click SP - SP Profiles.
2. In the User SP Profiles list, select the SP profile you wish to delete and click Delete.
To modify a user SP profile:
1. Click SP - SP Profiles.
2. In the User SP Profiles list, click the name link for the SP profile you wish to modify and
enter the new information.
3. Click Apply.
Managing Default Users (Admin users only)
To perform management operations through a MergePoint SP manager, a username and
password are required to access the SP. To simplify the authentication process, you may
configure a default username and password for specific SPs. When a management operation is
requested, the MergePoint SP manager searches the entire list of default usernames to see if
there is an appropriate one for accessing the SP. You may create multiple entries of the same
username with a different password for each. One preset username and password for each type
of SP is created by default.
Type Username Password
IPMI 1.5 admin admin
IPMI 2.0 admin admin
IBM RSA II USERID PASSW0RD
IBM BladeCenter USERID PASSW0RD
DELL DRAC 3 root calvin
DELL DRAC 4 root calvin
Table 2.6: Default Service Processor Usernames
and Passwords
Chapter 2: Installation and Setup 43

Avocent MERGEPOINT SP MANAGER Specifications

General

Brand	Avocent
Model	MERGEPOINT SP MANAGER
Category	Network Hardware
Language	English