5. Preparing the buttons
Both the LEDs o f the Button and the LEDs of the Ba se Unit are blinking white. This means pairing is in progress.
The Base Unit automatically ch ecks whether the s oftware of the Button is up to date. If not, the Base Unit updates the B utton
software. This m ay take more time.
During the pairing and update pr ocess, a message is displayed on the screen: “Pairing and updating B utton. Busy pairing and
updating”
Image 5-2
Pairing mes s age
The result of the pairing process can be as follows:
- When the LEDs become static white, the Button is paired to the B ase Unit, but no software update was needed. You can
unplug the Button from the Base U nit.
- When the LEDs become static red, the Button is paired to the Base Unit and the s oftware update has finished. You can unplug
the Button from the Base Unit.
Image 5-3
Pairing finished
2. Unplug the Button from the Base Unit.
Image 5-4
Unplug Button from Base Unit
The B utton is now ready for use.
5.2 P re-install of the Launcher service
Launcher service pre-install
The ClickShare Launcher service can be pre-installed on your laptop or on company level. How this is done depends on your IT
infrastructure.
When the L auncher s ervice is pre-installed, a launcher application run s in the background. When you plug the Button in your laptop,
the ClickShare application will be run from the Button automatically. There is no need to run the file from the Button.
The pr e-installer can be do wnloaded from the Base Unit’s web interface and the Barco website.
36
R5900004 CLICKSHARE 23/12/2014
To Next Page
Loading...
Need help?
General
