4. ClickShare installation
Image 4-30
4.12 About Network integration
Introduction
The ClickShare network integration option is aimed at deploying ClickShare in larger organizations without interfering with the ex-
isting wireless network infrastructure. In a default stand-alone setup, the C lickShare Base Unit will always create it’s own wireless
access point (AP) w hich the ClickShare B uttons use to connect. These so-called “rogue” APs can bec ome a nuisance in larger
installations. Next to that, m eeting participants who ar e sharing c ontent from mobile devices have to switch networks to connect
withtheClickShareBaseUnit.
This is where the ClickShare Network Integration c omes in. O nce fully con figured and enabled the built-in AP of the Base Unit will
be disabled and the Button will instead connect to a wireless ac cess point which is part of the corporate network. At this point the
Base Unit will need to be connected to the corporate network via the wired E thernet interface in order for the Buttons to be able to
share their content on the Base U nit.
Corporate Network
Laptop
Tablet
Access
Point
ClickShare Base Unit
DVI/DP/HDMI
Image 4-31
Security modes
There are 2 s ecurity types that are supported by the Button to connect to the c orporate network.
32
R5900004 CLICKSHARE 23/12/2014
To Next Page
Loading...
Need help?
General
