12. Alignment
How to activate - deactivate
1. Press Menu to activate the menus and select Alignm ent → Warping → .Warp status.
Image 12-24
Main menu, alignment
Image 12-25
Alignment, Warping
Image 12-26
Warping status
2. Press ENTER to toggle between [On] and [Off].
[On]: warp functionality is activated.
[Off]: warp functionality is disabled.
12.8.3 Start up manual adjustment
How to start up
1. Press Menu to activate the menus and select Alignm ent → Warping → .Warp adjust.
The Warp adjust menu opens.
The content of this warp adjust menu depends on the selection. When no warp was done before, the menu starts as a sort of
wizard by opening only the warp area pane. It opens more and more panes depending on the selection. When manual warping
was done before the menu opens with the same layout as it was last used.
A warp grid and adjustment points is displayed on the screen. The maximum grid is 32 points by 32 points.
R5905032 HDX SERIES 20/11/2014
173
To Next Page
Loading...
