Barco HDX - Warp Board and Values Reset

12. Alignment
Image 12-91
Main menu, alignment
Image 12-92
Alignment, Warping
Image 12-93
Warp board reset
2. Press ENTER to start the board reset.
12.8.23 Warp board and values reset
What can be done?
With some extreme warp values the hardware of the warping can get stuck. With only a hard reset of the board, it starts up with
the same extreme values and get stuck immediately. So that is not the solution. Therefore, while executing a hard reset, the warp
values are reset at the same time so that the board can start up.
How to reset board and values
1. Press Menu to activate the menus and select Alignm ent → Warping → .Warp board a nd values reset.
192
R5905032 HDX SERIES 20/11/2014