3. Physical installation
Image 3-23
Lens calculator
The Lens Calculator can also be used to determine the position of the projector when the lens type and screen
width is known.
3.2.3 Lens installation
How to install
1. Remove the foam rubber in the opening of the lens holder if not removed yet.
2. Take the lens assembly out of its packing material and remove the lens caps on both sides.
3. Place the lens holder in the “unlocked” position by moving the lens lock handle (A) towards the lens power supply socket (B) as
illustrated.
A
B
Image 3-24
Lens installation, preparation
4. Ensure that the lens holder stands in the On-Axis position (horizontal and vertical mid position).
Note: The lens holder is placed de fault in the On-Axis po sition at factory.
5. Gently insert the lens in such a way that the lens connector matches the socket (B).
R5905032 HDX SERIES 20/11/2014
29
To Next Page
Loading...
