12. Alignment
Or,
press ENTER when an item is selected and use the 4 arrow keys to adjust.
Image 12-43
Warping, keystone
5. Move the corner points to the desired position.
Image 12-44
Keystone adjustment
12.8.9 Linearity adjustment, workflow
Adjusting vertical and horizontal linearity
1. Select the 2 x 2 adjustment level. See "Setting the warping level", page 177.
The default selected anchor point is the left top corner of the image.
2. Select the desired warp area.
Depending on the selected area only the points in that area will be adjusted.
3. Select Linearity.
4. Select within Warp Adaptations, Horizon
tal or Vertical to adjust the corresponding keystone.
Or,
press ENTER when an item is selected and use the 4 arrow keys to adjust.
Image 12-45
Warping, Linearity
5. Adjust the horizontal and vertical linearity.
To fine tune this adjustment, select a specific area and add extra anchor points by changing the warp level.
180
R5905032 HDX SERIES 20/11/2014
To Next Page
Loading...
