Barco HDX - Light Output Configuration Via OSD Menu

13. Projector Control
Tolocktoaspecific value a 4 digit code is necessary; These codes can be created by the projector owner using Projector Toolset.
13.15.2 Light output configuration via OSD menu
What can be done ?
The activation code can be entered by the projector user. This code is validated and when valid the maximum light output is set
accordingly.
How to set
1. Press Menu to activate the menus and select Projector Control.
Image 13-148
Main menu, projector control
2. While Pr ojector C ontrol is selected, enter the hidden code “8069”.
A Device configuration menu opens.
Image 13-149
Projector control, device configuration
3. Enter the 4 digits of the activation code using the digit keys on the remote control or the local keypad.
If the code is correct, the message: “Device successful configured as <projector name>” is displayed and the projector is set to
corresponding maximum light output.
Image 13-150
Successful configured
If the code is incorrect, the message: “Invalid attempt!”, is displayed:
Image 13-151
Invalid attempt
After 3 invalid attempts, the message: “Invalid attempt! Try again after 300 seconds” is displayed.
Image 13-152
264 R5905032 HDX SERIES 20/11/2014