Barco MDSC-1119 - SRP Sharpness Control

Overview of Commands
MDSC-1119 and MDSC-2124_________________________________________________________________14
4.5.5. SRP
Adjusts and gets information about the sharpness of the display.
Command Minimum to Maximum Sharpness
CMD 0 - 20
RV
MM
Mm
SRP
• CMD
Sets sharpness value
Example: CMD,SRP,10
Response: 10
• RV
Reads the current sharpness
Example: RV,SRP
Response: 10
• MM
Returns the maximum sharpness
Example: MM,SRP
Response: 20
• Mm
Returns the minimum sharpness
Example: Mm,SRP
Response: 0
4.5.6. APOS (Autosetup)
Automatically adjusts the geometry of the image input. Make sure a valid test pattern
such as a full white image is displayed.
Command
CMD
APOS
• CMD
Starts auto position (geometry) calculation
Example: CMD,APOS
Response: n/a
4.5.7. AGC (Autosetup)
Automatically adjusts the gain of the image input. Make sure a valid test pattern, one
containing at least 1 8x8 group of pixels of full black and full white.
Command
CMD
AGC