Barco MDSC-1119 - OSD Priority Control

Overview of Commands
MDSC-1119 and MDSC-2124_________________________________________________________________47
• RV
Reads DPMS status
Example: RV,DPMS
Response: 1 = display in standby 0 = display normal
• MM
Returns: 1 = enabled
Example: MM,DPMS
Response: 1
• Mm
Returns: 0 = disabled
Example: Mm,DPMS
Response: 0
4.12.2. OSD
This command gives the OSD or ASCII communication the priority on the display. At
default (OSD = 0) ASCII commands sent will automatically close the OSD menu when
enabled ASCII commands will have no affect and return a “NACK” when the menu is
open. This can be used as a safety incase the user would like to have absolute control
of the display via the OSD even when a machine is sending ASCII commands.
Command
CMD
0/1
RV
MM
Mm
OSD
• CMD
Enables / disables OSD priority 1 = OSD priority 0 = ASCII priority
Example: CMD,OSD,1
Response: 1
• RV
Reads OSD priority status
Example: RV,OSD
Response: 1 = OSD priority 0 = ASCII priority
• MM
Returns: 1 = OSD priority enabled
Example: MM,OSD
Response: 1
• Mm
Returns: 0 = priority disabled
Example: Mm,OSD
Response: 0