Barco MDSC-1119 - GPIOT GPIO Text Entry

Overview of Commands
MDSC-1119 and MDSC-2124_________________________________________________________________37
*Note: When GPIO switch 1 and 2 have the same functionality only GPIO switch 1 is
used.
Command Image Function Resulting GPIO type
CMD
1 / 2 0
1
2
3
Disabled
Input
Text
PIP Order
RV 1 / 2
MM
Mm
GPIO
• CMD
Sets the GPIO function
Example: CMD,GPIO,1,3
Response: 1:PIP Order
Example: CMD,GPIO,2,2
Response: 2
• RV
Reads the GPIO function number
Example: RV,GPIO,1
Response: 1
• MM
Returns maximum GPIO function number
Example: MM,GPIO
Response: 3
• Mm
Returns minimum GPIO function number
Example: Mm,GPIO
Response: 1
4.9.10. GPIOT (for text mode only)
This command enters new text or reads the text set for the GPIO text function. The
text string must be less than the maximum string length which is 16 characters.
Command Image GPIO Text
CMD
1 / 2 camera 3
RV 1 / 2
MM
Mm
GPIOT