EasyManua.ls Logo

Barco MDSC-1119 - BAUD RS232 Baud Rate

Barco MDSC-1119
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Overview of Commands
MDSC-1119 and MDSC-2124_________________________________________________________________39
RV
Reads the GPIO position
Example: RV,GPIOP,1
Response: 1
MM
Returns maximum GPIO position
Example: MM,GPIOP
Response: 6
Mm
Returns minimum GPIO position
Example: Mm,GPIOP
Response: 1
4.9.12.
GPIOTR
This command selects trigger settings pulse/level for GPIO inputs.
Command Image Trigger Number Resulting Trigger
Level
CMD
1 / 2
0
1
Level
Pulse
RV 1 / 2
MM
Mm
GPIOTR
CMD
Sets the GPIO trigger value
Example: CMD,GPIOTR,1,1
Response: 1
RV
Reads the GPIO trigger value
Example: RV,GPIOTR,1
Response: 1
MM
Returns maximum GPIO trigger value
Example: MM,GPIOTR
Response: 1
Mm
Returns minimum GPIO trigger value
Example: Mm,GPIOTR
Response: 0
4.9.13.
BAUD
This command selects the RS232 baud rate values for RS232 communication.
*Note: Changing the baud rate of the display will also require a change of baud rate on
your terminal or software to maintain communication.

Other manuals for Barco MDSC-1119

Related product manuals