Field Service Manual December 2003
Page 148 of 276
FRQ COR DEL FRQ COR DEL
B 0 3000 0 829 B 1 2777 0 832
B 2 2975 0 674 B 3 2751 0 676
…
B 20 2942 0 211 B 21 2713 0 214
B22 2945 0 57 B23 2770 0 61
By choosing a beam, you can alter the frequency and the delay
beam: 11
B11 Frq = 2700:.... (type new value : 2000<frq<4000)
B11 del = 1012 :.... (type new value : 0<del<5000)
Parameter ver 8.0 your choice: A
When you choose A in LTL-mode, and no tuning has been performed,
you will see the default values of the amplification factor and
tune correction for each beam. If tuning is done for a certain intensity,
you see the values which correspond to that intensity.
When you choose A in EXPOSE-mode, you see the values which were
found for the asked resolution.
The default value for T.Cor is 1000, then all the beams will be tuned
to the value of par 91. The tuned value for each beam can be changed
into steps 0.1% of par 91.
V8.0 Your Choice: A
Amp T.Cor Amp T.Cor
B 0 336 1000 B 1 396 1000
B 2 343 1000 B 3 357 1000
…
B 20 468 1000 B 21 460 1000
B22 484 1000 B23 450 1000
V8.0 beam : Q
V8.0 your choice :
Parameter ver 8.0 your choice: O
By choosing O, you can fill in the resolutions of the Imagesetter.
These resolutions are then displayed in the B option. In the B option
you can fill in the number of beams for each resolution.
e.g. the O parameters
Parameter ver 8.0 your choice : O
NR DPI NR DPI
N 0 DPI=2000 N 1 DPI=4000
N 2 DPI=4064 N 3 DPI=8000
N 4 DPI=8128 N 5 DPI=16000
N 6 DPI=20000 N 7 DPI=20320
V8.0 dpi : quit
Remark : Influence of resolution position in ‘O-table’ and number of beams in‘B-
table optics’ on parameter 91.
Parameter ver 8.0 your choice: N
To Next Page
Loading...