Field Service Manual December 2003
Page 149 of 276
It is possible to root a pin number from SSIPRO to a beam number. The
correct rooting depends on the physical position of the DRV4x3-boards in
the Multibeam BOX, the physical connection of coax cables to the AOM
and which projection to be made (SW, 748xx and 758xx).
For 748xx machines cables on the modulator are swapped over.
BNR PNR PNR BNR BNR PNR PNR BNR
B 0 P 0 P0 B 0 B 1 P 1 P 1 B 1
B 2 P12 P2 B 4 B 3 P13 P 3 B 5
...
B20 P10 P20 B18 B21 P11 P21 B19
B22 P22 P22 B22 B23 P23 P23 B23
Parameter ver 8.0 your choice: I
This parameter is intended to be used as a mask for screen information.
21 Diagnostics level : ______ ______: 577
Diagnostic Info :
- general : Y
- chartcon : N
- carriage : N
- tuning : N
- knife : Y
- user info : Y
- batch s/s : N
- frm batch : N
- s/rfdrel : N
- FF info : N
- FF debug : N
- RIP debug : N
- CS debug : N
- R&D debug : N
- scaler : N
- DRV debug : N
Parameter ver 8.0 your choice: F
Filmfeed Parameters
See chapter “Film Feeder” - “The Filmfeeder parameter settings”
Parameter ver 8.0 your choice: E
Listing of expose parameters.
| PPI | 2000 | 4000 | 5080 | 8000 | 10160 | 16000 | 20000 | 20320 |
| BEAMS | 24 | 24 | 24 | 24 | 24 | 24 | 24 | 24 |
| POWER | 2000 | 1900 | 1500 | 800 | 550 | 280 | 180 | 180 |
| FDUTY | 28 | 13 | 10 | 6 | 4 | 2 | 2 | 2 |
| O-PPI | 2000 | 4000 | 5080 | 8000 | 10160 | 16000 | 20000 | 20320 |
| SPEED | 26000 | 26000 | 26000 | 26000 | 26000 | 26000 | 25000 | 25000 |
To Next Page
Loading...