56-101-01175 Revision H Page | 31
Figure 19 Default 2-Channel (Dual Ps, Pt) mode
Figure 20 Optional 1-Channel (Pt Only) Mode
Note: Please refer to Appendix D for the complete Menu Navigation
7. TEST SET CONFIGURATION STATUS DISPLAY
The Test Set presents the Configuration Status information in the top right quadrant of the
display. The following information is included:
A. Mode: 2-channel, Ps & Pt or 1-channel, Pt Only
B. Limits: Indicates the limits profile currently in use
C. Altitude Correction: Indicates the correction factor entered by the user. Default = 0
unless user specifies otherwise
D. Auto Leak Recovery: Enabled or Disabled
Note: The Configuration Status area is an active touch zone the user can navigate
by either pressing the top right box or selecting this Menu sequence: Main
Menu, Page 2, Setup 1.
To Next Page
Loading...
