56-101-01175 Revision H Page | 41
When the AutoZero function is performed, the CB valve (Sv_CB) is OPEN.
Figure 35 Conclusion of Go To Ground
After a Go To Ground function is performed, Test Set will remain vented to ambient.
F. Setup 1 – The following is available under this set of menu(s):
Figure 36 Setup 1
Main Menu: Page 2, Setup 1
1. Auto Leak Recovery – When the Test Set is operating in Leak Measure mode and
Auto Leak Recovery is Enabled. If a high leak rate occurs (High ROC or RtCAS),
To Next Page
Loading...
