56-101-01175 Revision H Page | 75
CHAPTER 5: RECEIVING, SHIPPING, AND STORAGE
1. RECEIVING
No special unpacking procedures are necessary. It is recommended that the factory-
shipping container and packing materials be retained should it become necessary to re-
ship the Test Set for a variety of reasons, including O.E.M. recertification.
It is also recommended that the Test Set undergoes a leak check upon receipt and its carrying
case should be carefully inspected for damage. If the Test Set has an excessive leak or is
damaged, immediately notify the carrier and the manufacturer.
2. SHIPPING
A. It is recommended that the factory-shipping container and packing materials be
retained should it become necessary to re-ship the Test Set for a variety of reasons,
including O.E.M. recertification.
B. Ensure the unit is Safe at Ground.
C. Disconnect hoses from the Static and Pitot ports and install AN4 caps on each.
D. Ensure unit is powered off. Disconnect the power cable and store in lid pouch.
E. Reaffix the lid if previously removed.
F. Use standard delicate electronic equipment packaging procedures when packing the
Test Set for reshipment.
3. STORAGE
A. Place a four-ounce bag of desiccant inside the case.
B. Close and latch the cover.
C. Store in a cool dry place.
Note: Should the Test Set become exposed to moisture or very high humidity, dry it as
soon as possible and temporarily store it in a dehumidified area.
To Next Page
Loading...
