1. Introduction
An optional laptop computer with the following minimum
capabilities is recommended:
• CD-ROM reader
• 64 MB RAM
• 3 GB hard drive
• Pentium, 233 MHz or similar
• Acrobat Reader 4.0 or higher
• Modem, 33.6k
1.7 TESTING AFTER PARTS REPLACEMENT
All maintenance actions performed on the Instrument must be
concluded with a complete calibration, verification, and testing of
the system(s) impacted by the maintenance actions, including
component swapping and replacing.
Refer to Section 19, Functional Verification, for detailed
information.
1.8 MANUAL REVISIONS
From time to time there are changes in technical procedures and
part numbers. Updates to this manual will be made by sections as
listed in the Table of Contents. In each case, both the cover and
the Table of Contents will also be updated to show the new
revision date.
Information regarding these changes is distributed through
Technical Service Bulletins, which are posted on the Internet,
URL:
http://www.baxter.com/services/renal_services/technical_publications/index.html
You may also send your E-mail address to: tech_talk@baxter.com
requesting Technical Service Bulletin notification and we will
notify you by e-mail you when new information becomes available
on the Internet.
This information may be available as hard copies, or on the Baxter
Intranet.
1.9 QUESTIONS AND FEEDBACK
If you require further technical assistance in the USA, please call
Baxter Instrument Services at 1-800-553-6898. Outside the USA,
please contact your local Baxter Technical Support Group.
157-1278-896, Rev A 1-15
March 2004
To Next Page
Loading...
