BAYKON MX08 - Page 123

MX08 Multichannel Weighing System, Technical Manual, Rev. 2.5 Page 121 of 144
The meanings of the annunciater LEDs in operation are given below.
LED
Symbol Name
Pwr Power
MX08 EC is not powered. Check power cable.
MX08 EC is powered.
Lnk Link
No data transmission done.
Data transmission done to xFace or Modbus-RTU
Err Error
No Error found.
Error: Look at the error table in Section 9.6.
Blank Light Flash Blank for 0.3 second
Table 12.1 - Annunciater LEDs
RUN LED
LED State
Description
Off
INIT
Green
OPERATIONAL
Green, blinking
PRE-OPERATIONAL
Green, single flash
SAFE-OPERATIONAL
Red
(Fatal Event)
LINK/Activity LED
LED State
Description
Off
No link, no activity
Green
Link sensed, no activity
Green, flickering
Link sensed, activity exist.
ERR LED
LED State
Description
Off
No any error ( or no power )
Red, blinking
Invalid configuration; State change received from master is
not possible due to invalid register or object settings.
Red, single flash
Unsolicited state change; Slave device application has
changed the EtherCAT state autonomously.