BAYKON MX08 - Electrical Connections; Power Supply and Grounding

MX08 Multichannel Weighing System, Technical Manual, Rev. 2.5 Page 16 of 144
Figure 2.2 - Din rail installation
3.3. Electrical Connections
Warning: Please always remember that MX08 AD instruments are very low voltage
measuring instruments. Your control cabinet design and proper installation increases
reliability and performance of the instrument. Please do not forget that the instrument must
be powered off before inserting or removing any peripheral connector.
All required electrical connections should be done as described below.
3.3.1. Power Supply and Grounding
Power supply voltage of the instrument shall be between 12 VDC and 28 VDC. The
current resumption of the power supply will be calculated by multiplying 0,2A and the
quantity of instruments. The pin configuration of the 24 VDC power supply connector
located front bottom of the instrument is shown in Figure 2.3 below.
The pin layout of the 24 VDC connector of
MX08 AD and MX08 IO
( front view )
24V 0V
The pin layout of the 24 VDC connector of
MX08 MB, MX08 PB, MX08 PN, MX08 EN,
MX08 EI, MX08 EC and MX08 PL
( front view )
24V 0V Shield
Figure 2.3 - The pin layout of 24VDC connector