BAYKON MX08 - Ethernet Parameters on Etherx

MX08 Multichannel Weighing System, Technical Manual, Rev. 2.5 Page 97 of 144
Modbus TCP/IP
Low-High
:
Modbus TCP/IP communication. Refer to Section 10.5 for details.
Note: xFace automatically connects to the instrument whatever the data format is. After
xFace disconnection, the instrument returns to run with last saved data format.
Checksum
The checksum can be enabled or disabled from BSI data format. The checksum
calculation can be found in the related data format description.
Default is ‘Enable’.
11.4.2. Ethernet Parameters on EtherX
There are 11 parameters for Ethernet network.
Host Name
Device name of the instrument.
Default is ‘ ’.
IP Address
Obtain IP address manually.
Default is ‘192.168.16.250’.
Local Port
Ethernet connection port of the instrument.
Default is ‘10001.
Gateway
Network point that acts as an entrance to another network.
Default is ‘192.168.16.254’.
Subnet Mask
Describes IP address can be used in network.
Default is ‘255.255.255.0’.
Primary DNS
Obtain primary DNS manually.
Default is ‘208.67.222.222’.
Secondary DNS
Obtain secondary DNS manually.
Default is ‘208.67.220.220’.