Weekly Maintenance
Clean Total Protein and Albumin Cup Modules (DxC 800 Only)
Maintenance UniCel DxC Systems Instructions For Use A13914
Page 10-10 October 2005
Clean Total Protein and Albumin Cup Modules (DxC 800 Only)
Total Protein and Albumin modular reaction cups and stir bars should be cleaned
weekly, or more frequently if the chemistry will not calibrate, or when chemistry
performance indicates.
3 Install new wiper (1) by sliding it onto the bottom of the probe until the
under surface of the wiper is flush with the end of the probe.
Note: The wiper tip should be square to the cuvette. The under surface of
the wiper should be flush with the end of the washer probe.
Figure 10.3
4 Replace the upper section of the cuvette wash assembly and tighten the
thumbscrews finger-tight. Make sure the wash assembly is seated properly
on the mounting pins.
5 Verify that all four wash tower probes are centered over a cuvette. Failure
to do so may cause a flood.
6 Reinstall the cuvette wash station cover.
Step Action, continued
(2 of 2)
NOTICE
For convenience, the Total Protein and Albumin Cup Maintenance procedure is
also included with the other modular chemistries in Monthly maintenance.
Weekly Total Protein and Albumin Cup Maintenance should be performed at
equally distanced intervals.
NOTICE
The system must be in Standby in order to access the Maintenance mode.
To Next Page
Loading...
Need help?
General
