Always use the most recently BOSS Console Software to program the ABSOLUTA.
Installation of the system must be carried out strictly in accordance with the instructions described in this manual, and in
compliance with the local laws and bylaws in force.
The GSM, ABS-GSM and IP, ABS-IP modules must be installed by Service Persons only (service person is defined as a
person having the appropriate technical training and experience necessary to be aware of hazards to which that person may be
exposed in performing a task and of measures to minimize the risks to that person or other persons).
The GSM, ABS-GSM and IP, ABS-IP modules must be installed and used within an environment that provides the pollution
degree max 2, over voltages category II, in non-hazardous, indoor locations only.
All instructions specified within thIS manual must be observed.
The ABSOLUTA Control Panels have been designed and manufactured to the highest standards of quality and performance.
The ABSOLUTA Control Panels have no user-changeable components, therefore, they should be serviced by authorized
personnel only.
BENTEL SECURITY does not assume responsibility for damage arising from improper application or use.
The manufacturer recommends that the installed system should be completely tested at least once a month.
Hereby, BENTEL SECURITY, declares that ABSOLUTA Control Panels comply with the essential requirements and other
relevant provisions of Directive:
2006/95/EC The Low Voltage Directive
2004/108/EC The Electromagnetic Compatibility Directive
99/55/EC The R&TTE Directive
This panel complies with EN50131-1: 2008, EN50131-3: 2009 and EN50131-6: 2008
MAINTENANCE
Please verify the correct operation of security system at least once a month.
Periodically, perform the steps below.
— Remove dust accumulation on the panel container, with a damp cloth without use any type of solvent.
— Check the status of the connections and wires.
— Check inside the panel there are no foreign bodies.
— For other security-system devices, such as smoke detectors, infrared and microwave detectors, and inertial detectors, refer
to the instructions for maintenance and testing.
RECYCLING INFORMATION
BENTEL SECURITY recommends that customers dispose of their used equipments (panels, detectors, sirens, and other
devices) in an environmentally sound manner. Potential methods include reuse of parts or whole products and recycling of
products, components, and/or materials.
For specific information see: http://www.bentelsecurity.com/index.php?o=environmental
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE) DIRECTIVE
In the European Union, this label indicates that this product should NOT be disposed of with household waste. It should
be deposited at an appropriate facility to enable recovery and recycling.
For specific information see: http://www.bentelsecurity.com/index.php?o=environmental
BENTEL SECURITY srl. reserves the right to change the technical specifications of this product without prior notice.
*) See Table 2 on page 7.
**)See Table 2 on page 7.
To Next Page
Loading...
