WLS zone type
1=int._ 2=delay_
9. Set up the Wireless Zone Type, then press ENTER
and go back to step 5.
Ø
1:Internal.
Ø
2: Delayed.
Wireless Keys
WIRELESS Config.
Key 001
10. Select the required Position (Slot) for the Wireless
Key, then press ENTER.
note:ON=E, OFF=F
ESN ------
11. Enter the 6-digit Electronic Serial Number you can
find on the Wireless Key, as per the Wireless De
-
tectors.
note:ON=E, OFF=F
ESN 6989E2
12. Press ENTER and go back to step 5.Wireless De-
tector
Placement Test
WLS placem. Test
Zone 013
13. Select the (Detector) Wireless Zone to test, then
press ENTER.
+
The display prompts the first Wireless Zone of the
System.
Result .....
14. Perform the Placement Test as indicated in the De
-
tector’s instructions.
Result .....
GOOD!!
Ø
If the result is GOOD, you can mount the detector in
the selected placement: press ESC and go back to
step 13.
Result .....
BAD!!
Ø
If the result is BAD, you must move the Detector in a
different position and try again: press ESC and go
back to step 13.
2.4) Key enrolling
You can enroll the Digital Keys as follow.
1. Access the Installer menu, as indicated in the para
-
graph “Access to the operations”.
INSTALLER
1act. 2prg 3view
2. Select the Programming option by pressing 2.
INSTALLER 2.1
Voice Messages
3. Select Key programming.
INSTALLER 2.4
Key programming
4. Press ENTER.
Key programming
on Reader ---
5. Select the Key Reader to enroll the Keys, then
press ENTER.
Key programming
Key ---
6. Select the Key slot, then press ENTER: ALL the se-
lected Key Reader’s LEDs fast blinking to indicate
that it is waiting for a Key.
+
if the display shows the message Key active,
the selected slot is already used by a Key. Press
ESC and select a free slot or press ENTER to over
-
write the position with the new Key.
Key programming
Wait for key
7. Present the Key to the selected Key Reader: the
green indicator light and the Keypad sounds a dou
-
ble beep to indicate that the Key has been enrolled
and go back to step 6.
+
if the display shows the message Key used, the
yellow indicator on the Reader blinks quickly and
the Keypad sounds a single beep, the key is al
-
ready enrolled on a different slot. Press ESC and
go back to step 6.
ABSOLUTA KEYPAD OPERATIONS 99
To Next Page