In AND Group If this option is enabled, the Key must
be used with another Key or Code to Disarm its Parti
-
tions, as set in the And Keys Codes Num option (refer
to the “Partition” Option Group").
Key Timer If this option is enabled, the Key will be able
to perform its programmed functions ONLY during its
Timer slots (see Timers options group).
Key Presence If this option is enabled, the Key can be
programmed and used for system access.
Many applications require fewer Keys. This option will
allow you to enable only the required number of keys,
thus simplifying the programming process while in
-
creasing the security level. keys which have not been
made Available can be considered inexistent.
Partitions If disabled, the Key CANNOT manage the
Partition.
If ENABLED, the Key can manage the Partition.
Default: ONLY Partition n. 1 is enabled.
Codes and Keys: Keyfobs
This Option group is to setup the Keyfobs (Wireless
Keys), as follow.
Label This option is to enter a significant description of
a keyfob.
Wireless Device Serial Number This option is for the
ESN (Electronic Serial Number) of the Wireless key.
The ESN will allow the Control Panel to identify the wire
-
less key on the system.
The ESN may comprise hexadecimal digits (A, B, C, D,
E and F), in order to lower the risk of duplicate ESNs.
+
Some Wireless Devices have 5-digit and 6-digit
ESNs (printed on back), use ONLY 6-digit ESNs
with this Control Panel.
Enabled If this option is enabled the Keyfob can con
-
trol the system.
If this option is disabled the Keyfob cannot control the
system, however, it can still be programmed by a Mas
-
ter PIN.
Master PINs can toggle the Enabled status of the
keyFobs (also via the User Menu).
KeyFob Presence If this option is enabled, the Keyfob
can be programmed and used for system access.
Many applications require fewer Keys. This option will
allow you to enable only the required number of
Keyfobs, thus simplifying the programming process
while increasing the security level. Keyfobs which are
not present can be considered inexistent.
Timer If this option is enabled, the Keyfob will be able
to perform its programmed functions ONLY during its
Timer slots (see Timers options group).
Partitions If enabled, the keyfob does NOT manage
the partition.
If ENABLED, the keyfob can manage the partition.
Default: ONLY partition n. 1 enabled.
Mode A This option is to setup the action on the Parti
-
tion when the Wireless key performs the A Mode Arm
-
ing, as follow.
Ø
Away Arm: Partition will Arm in Away mode.
Ø
Stay Arm: Partition will Arm in Stay mode.
Ø
Instant Stay: Partition will Arm in Stay mode with
zero delay (Instant).
Ø
Disarm: Partition will Disarm:
Ø
No Action: the Partition does NOT change its state.
Default: Stay arming of Partition 1.
Mode B As per Mode A but for B Mode Arming.
Default: Zero Delay Stay Arming of partition 1.
76 Expandable Hybrid Control Panel
To Next Page
Loading...
