1.8) Clear Faults and Tampers
You can clear fault and tamper signalling as follow.
1. Access the Installer menu, as indicated in the para
-
graph “Access to the operations”.
INSTALLER
1act. 2prg 3view
2. Select the Action option by pressing 1.
INSTALLER 1.1
ZONE test
3. Select Clear Fault/Tamp.
INSTALLER 1.8
Clear Fault/Tamp
4. Press ENTER.
Clear Fault/Tamp
1=Fau._ 2=Tam._
5. Select the action required by pressing the relative
key.
Ø 1: the Fault signalling will be cleared.
Ø 2: the Tamper signalling will be cleared.
Clear Fault/Tamp
1=Fau.* 2=Tam.*
6. Press ENTER to perform the selected actions.
Clear Fault&Tamp
Are you sure?
7. Press ENTER again to confirm your choice or press
ESC to go back to step 5.
Clear Fault&Tamp
Done !!
8. Press ESC to go back to step 3.
1.9) Option Programming by Keypad
You can programming the main Control Panel options
by an LCD Keypad as follow.
1. Access the Installer menu, as indicated in the para
-
graph “Access to the operations”.
INSTALLER
1act. 2prg 3view
2. Select the Action option by pressing 1.
INSTALLER 1.1
ZONE test
3. Select Panel Prog.
INSTALLER 1.9
Panel Prog.
4. Press ENTER.
Panel Prog.
Zones Zn---
5. Select the Option Group you want set up by press-
ing a and b then press ENTER and refer to the rela-
tive paragraph.
+
The Installer Menu Timeout is suspended during
the Option Programming. The keypad exits from
the Installer Menu when you press ESC after the
Installer Menu Timeout has expired.
n Zones
Panel Prog.
Zones Zn---
The Zone option let you to set up the Zone Partitions as
follow.
1. Enter the Identification Number of the Zone you
want set up.
Zone 001
Zones Zn001
2. Press ENTER.
Zones Zn001
Part mask
3. Press ENTER again: the characters on the display
bottom line show the Partitions of the selected
zone: the 1st is for Partition 1, the 2nd is for Partition
2 and so on, as follow.
Ø
*: the Zone is assigned to the Partition.
Ø
-: the Zone is NOT assigned to the Partition.
ABSOLUTA KEYPAD OPERATIONS 95
To Next Page