KEYPAD OPERATIONS
You can perform the following operation from any LCD
keypad connected to the Control Panel, depending on
your access level.
Operation
Installer Level
Level 4
View Alarms Yes Yes
Reset Alarms Yes
View Tampers Yes Yes
Reset Tampers Yes
View Faults Yes Yes
Reset Faults Yes
View Bypasses Yes Yes
View Partition Status Yes
View System Status Yes Yes
1.1) Zone Test Yes
1.2) Output Test Yes
1.3) Changing the PIN Yes Yes
1.4) Firmware Upgrade by an USB key Yes
1.6) Modify the LCD Keypad language Yes
1.7) Enabling Level 4 access Yes
1.8) Clear Faults and Tampers Yes
1.9) Option Programming by Keypad Yes
2.1) Voice Message Recording Yes
2.2) BPI Device enrolling Yes
2.3) Wireless Device enrolling Yes
2.4) Key (card/tag) enrolling Yes
2.5) Message Download/Upload via USB Key Yes
2.6) Option Download/Upload via USB Key Yes
2.7) Factory Default Yes
2.8) Telephone Communicator Yes
2.9) Key Disabling/Enabling Yes
3.1) View Logger Yes
3.2) View the Firmware Version Yes Yes
3.3) View Zone Status and Zone Bypassing Yes
3.4) Display GSM Module Status Yes
3.5) Display IP Module Status Yes
+
The number before the bracket is for the direct ac
-
cess to the relative option, as indicated forward.
+
In this chapter we refer to the LCD Keypad: the op
-
erations on the Touchscreen Keypad are the
same, unless otherwise indicated
You have the following two access levels.
Ø
The Installer Level can perform all the operation
listed on the previous table, except for the “Firmware
Upgrade by an USB key”: the installer Level is dedi
-
cated to the installer of the system.
Ø
The Level 4 can only view the information about the
system (alarms, tampers, faults, bypass, status and
firmware version) and can perform the “Firmware
Upgrade by an USB key”: the Level 4 is dedicated
only to qualified people by the manufacturer.
+
The Installer Level access must be enabled by the
user, as indicated in the User Manual (OPERATING
YOUR SYSTEM FROM A KEYPAD>Program>En-
able Installer (Teleservice) (2.2)): enabled at default.
+
The Level 4 access must be enabled by the in-
staller as indicated in “1.7) Enabling Level 4 ac-
cess”: disabled at default.
Using the keypad
The following general rules for the keypad operations
are valid unless otherwise stated.
Ø
Press ENTER to confirm and go to the next step.
Ø
Press ESC to abandon and go to the previous step.
Ø
Press a and b to scroll the options.
Ø
Press c and d to scroll the values.
Ø
Press ON to enable an option.
Ø
Press OFF to disable an option.
ABSOLUTA KEYPAD OPERATIONS 87
To Next Page