Section 6 Evaluation Unit LB 442
63
Live Display
In this menu, the measured values are displayed continuously (live
display) for the selected product (display of RUN); otherwise the
values of the last measurement.
With <+> and <-> you can cycle through the following displays.
Start measurement
A measurement can be started from any menu item by pressing
the <run> button (exception: Service menu and calibration
points). Then the load is displayed. RUN appears on the display.
With <more> you can invoke further live displays and you can
scroll through them with <+> and <->. If the measurement is
stopped by pushing the <run> button, the load on the display and
at the current output switches to 0 t/h (kg/h) or shows the last
measured value. See also function "Load in case of stop" on page
51.
Totalizer (t or kg)
Display of integrated total weight in the selected unit.
If you continue with <->, the following menus appear:
Load (t/h or kg/h)
Display of load in the selected unit
Load dry (t/h or kg/h)
Display of dry load in the selected unit (only in operating mode
with moisture compensation).
Load total (t/h or kg/h)
Display of total load in the selected unit.
Detector temp. °C
Display of detector temperature
Tare Cps [Cps]
Display of tare count rate.
Act. count rate [Cps]
Display of actual count rate with on-going measurement or meas-
ured value of last measurement.
Current output actual mA
Display of current output in mA.
Actual belt speed m/s
Display of belt speed
To Next Page
Loading...
