540
CONTROL STATION
Studio ti 03312 540-04usa
104
6
6.5 EMERGENCY CONTROL DEVICES
6.5.1 Engine stop control
Due to a mechanical or electric fault, the normal procedures of engines
stop could not work; it is therefore necessary to stop the engines by
means of stop button (1) located on the control panel of each engine.
During normal operation the emergency stop button must not be inserted.
When pressed it locks in low position and prevents the engine start.
To reset the system to normal operation, it is necessary to turn the button
clockwise until it unlocks and returns to original position.
S
CAUTION
Before starting the engines after an emergency stop, make sure that
you have found and cleared the faulty reason. For more information,
consult the CATERPILLAR manual.
S
CAUTION
The emergency stop controls of propulsion engines must be used only
in case of real emergency.
Do not activate this control during normal engines stop procedure.
To Next Page
Loading...