Bertram 540 - Swinging Table Lamp; Engineroom Overhead Light

540
14
MAINTENANCE
Studio ti 03312 540-04usa
321
14.8.3 Swinging table lamp
Bulb replacement
Prior to proceed with the bulbs
replacement, make sure that the
magneto-thermal switch protecting
the area in which the bulb to be
replaced is located, is
disconnected.
With light off and cold bulb: loosen
the terminal (1) and pull the light
unit out.
Pay attention during replacement
of the bulb, not to touch with your
fingers the glass of the new bulb.
After insertion of the new bulb,
follow the reverse sequence to
recover the previous conditions.
14.8.4 Engineroom
overhead light
Bulb replacement
Prior to proceed with the bulbs
replacement, make sure that the
magneto-thermal switch protecting
the area of the ceiling light is
disconnected. Remove the bulb
protecting glass by unscrewing
fixing screw with a screw driver.
Then replace the bulb. The bulb is
screw-tightened.
After insertion of the new bulb,
follow the reverse sequence to
recover the previous conditions.