Bertram 540 - Generator Lubrication System; Oil Specifications; Oil Check; Oil Change Procedure

540
ELECTRIC SYSTEM
Studio ti 03312 540-04usa
240
10
10.9 GENERATOR LUBRICATION SYSTEM
See the SCHEDULED MAINTENANCE section of the generator manual
for details about oil change and oil filter replacement intervals.
10.9.1 Oil specifications
Refer to the generator manual for oil specifications.
10.9.2 Oil check
Check the oil level in the crankcase daily or before each startup to ensure
that the level is in the safe range. To check the oil level, remove the
dipstick and wipe the end clean, reinsert as far as possible and remove.
Maintain the oil level between the Min and Max marks on the dipstick.
10.9.3 Oil change procedure
See manufacturer’s manual.

NOTICES
Failure to observe the oil specifications may cause inadequate
lubrication/oil pressure and cold-starting difficulties.

NOTICES
Do not operate the generator if the oil level is below the Min or above
the Max mark.