Bertram 540 - Engines Emergency Stop Procedure

540
GETTING UNDERWAY
Studio ti 03312 540-04usa
48
4
4.6 ENGINES EMERGENCY STOP PROCEDURE
Due to a mechanical or electric fault, the normal procedures of engines
stop could not work; it is therefore necessary to stop the engines by
means of EMERGENCY PROCEDURES.
− From engineroom
Press the red push-button located on the control panel of each engine
(aside each engine).
During normal operation the emergency stop button must not be
inserted. When pressed it locks in low position and prevents the
engine start.
To reset the system to normal operation, it is necessary to turn the
button clockwise until it unlocks and returns to original position.

NOTICES
The emergency stop generates a high stress in the engines with
consequent hazard of components damage. Use only in case of real
need.
k
DANGER
Before starting the engines after an emergency stop, make sure that
you have found out and cleared the faulty reason.
j
WARNING
The emergency stop controls of propulsion engines must be used only
in case of real emergency.
Do not activate these systems during normal engines stop procedure.