540
HYDRAULIC SYSTEMS
Studio ti 03312 540-04usa
208
9
9.9.4 Tank pump-out by shore pump
Observe local regulations that prohibit overboard discharge from holding
tanks. You may empty the black water (sewage) tank at the shore into a
designated shoreside pump-out station.
To empty the black water (sewage) tank into a shoreside pump-out
station, first make sure the yacht is moored correctly and the engines are
shut down.
Connect the shoreside suction hose to the yacht’s black water system,
using the waste outlet located on the port walk-around. When the line is
connected, activate the direct pump-out circuit by opening the suction
valve, located near the black water pump, located in the bilge below the
stateroom area.
When the draining is complete, remove the hose and firmly tighten the
cap of drain fitting.
WASTE fitting
To Next Page
Loading...