Bertram 540 - Bulb Replacement; Watertight Little Spotlights; Little Spotlights

540
MAINTENANCE
Studio ti 03312 540-04usa
320
14
14.8 BULB
REPLACEMENT
14.8.1 Watertight little
spotlights
The watertight lights are located
inside of heads and on the exterior
ceiling of the main deck.
With lights off and cold bulb:
periodically remove the salt
deposits from the light glass with a
cloth moistened with fresh water.
Bulb replacement
Before carrying out the
replacement of the bulbs, make sure to disconnect the circuit breaker
protecting the area of the built-in spotlight. With lights off and cold bulb:
remove the glass of the light, remove the bulb and replace the light. Pay
attention during replacement of the bulb, not to touch with your fingers the
glass of the new bulb. The bulb graft is of indent-type. After insertion of
the new bulb, follow the reverse sequence to recover the previous
conditions.
14.8.2 Little spotlights
Light unit replacement
Before carrying out the
replacement of the led unit, make
sure to disconnect the circuit
breaker protecting the area of the
built-in spotlight.
With lights off and led unit cold:
remove the glass-holder frame.
Force the retaining springs and
remove the holder of the led unit.
Replace the led unit.
During led unit replacement, do
not touch the new leds with your
fingers. The led unit graft is of
indent-type. After inserting the
new unit, follow the sequence in reverse order to restore initial conditions.
b
DANGER
The lights develop heat. Do not approach inflammables.