540
CONTROL STATION
Studio ti 03312 540-04usa
112
6
Press (1) to scroll through selections:
−
User Name;
−
Unit Location;
−
Unit Displays
ENGLISH, METRIC;
−
Vessel speed unit
KNOTS, NM/H, KM/H.
The parameters selections will be outlined on the display in white digits
on black background. When all correct parameters have been selected,
press (2) to exit the configuration mode. Then press (3) or (4) to return to
measuring displays.
Measuring displays
The measuring displays can be configured with three different types of
measures. The measuring instruments Analogical, Graphic, Bars and
Digital can be programmed according to the requirement of each
customer for the available engine parameters. Refer to display
manufacturer software for screen options.
Diagnostics
All engine diagnostics messages are supported by a visual indicator
sending an acoustic signal. If the diagnostics codes are not actuated, no
DIAGNOSTIC indicator will appear on measuring screens. When a fault
is detected, the DIAGNOSTIC indicator appears on the upper left corner
of the screen, as well as a window of diagnostics code description in the
center of the screen and the acoustic signal activates. Press the signal
reception button (1) to clear the alarm.
Press again the alarm reception key (1) to scroll to description window of
diagnostics code or clear it.
The DIAGNOSTIC code indicator remains on the screen until the fault is
removed.
Display modes
−
Daily Mode - Normal display is on white background with digits and
black meters. To increase or decrease the backlighting press and
hold (2) to visualize the backlighting bar. Adjust the backlighting with
arrows.
−
Night Mode - Press (2) to shift the display on night mode, with black
background and digits and red meters. To increase or decrease the
backlighting press and hold (2) to visualize the backlighting bar.
Adjust the backlighting with arrows. To increase or decrease the
backlighting, with back light lit, press again (2) to visualize the
backlighting bar. Adjust the backlighting with arrows. Press (2) to exit
from backlighting bar. Press (2) to return to Day Mode.
Signal loss on display
The signal loss on the display is shown on a DIAGNOSTICS with
description “no data link signal”.
To Next Page
Loading...