EasyManua.ls Logo

Bertram 540 - Page 346

Default Icon
392 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
540
TROUBLESHOOTING
Studio ti 03312 540-04usa
346
15
5. Air from the unit does not feel cool in the
“Cool” Mode or warm in the “Heat” Mode
− The selector switch is set for “Fan only”
− The thermostat is set incorrectly
− Water flow is restricted
− Switch the system into the “Cool” or “Heating”
mode
− Set the thermostat for a cooler or warmer
setting
− Clear restriction
6. The unit operates but the stateroom fails to
cool normally
− Dirty air filter
− The thermostat is set too high
− Clean lint screen or air filter
− Reset the thermostat to a cooler setting
7. Compressor cycle on and off − Dirty air filter
− Water flow restriction
− Clean lint screen or air filter
− Clear restriction
8. Water leaks in stateroom − Condensate drain is clogged
− Blockage in hose
− Clean out drain holes
− Clean hose. Check downhill routing of hose
Problem Cause Action

Table of Contents