Binder CB 160 - Data Transfer Via Usb Interface; Exporting Data to USB Drive

CB (E6.1) 07/2017 Page 69/145
10. Data transfer via USB interface
The USB port is located in the instrument box.
To access the submenus for data transfer, go to Menu > Import/Export
Fixed value
08.03.2013 05:05:06
Submenu “Import/Export to USB drive”.
Select the desired type of communication via USB
port (data export or import) and press the operating
button.
..\ Import/Export to USB drive
Export to USB drive
Import from USB drive
Close
Home
It is possible that some USB devices are not recognized due to compatibility issues. In this
case, please use a USB storage device from a different manufacturer.
10.1 Exporting data to USB drive
Insert the USB stick or the plug of your USB drive into the USB port in the instrument box.
To configure data export to USB media, go to Menu > Import/Export > Export to USB drive
Fixed value
08.03.2013 05:05:06
Submenu “Export to USB drive”.
..\ Export to USB drive
Chamber status
Measurement values
Event list
Configuration
Adjustment
Program parameters
System information
All
Close Home
Select the desired data type and press the operating button. Data is written to the connected media.
Chamber status Actual chamber status, including operating mode, setpoints etc.
Measurement values Measured data
Event list List of status information and errors (see chap. 12)
Configuration (Service only)
Adjustment Adjustment data
Program parameters (Service only)
System information
(Service only)
All
All data